Produkte von Paul Components

These 15mm replacement bearings are provided for servicing our front and rear hubs.They are manufactured by Enduro and feature two rubber seals which ride in a grooves machined into the bearing to prevent contamination.Bearings are sold...

There’s a bottle opener on one end, a 15mm brake spring adjuster on the other, and 56g of cool 6061 aluminium in between.

The Paul Comp Boxcar Stem is the perfect combination of stiffness, strength and reasonable weight and may be the coolest looking stem right now! This stem was designed from the ground up to be stiff, strong and pretty darn light too. The...

A pair of stainless steel Brake Pivot bushing for use with any of our brake post mounted brakes. Center Mount Racer and Racer Medium brakes use a special Center Mount Brake Pivot instead, which is included with the Racer Center Mount...

A pair of left and right Brake Springs for use with any of Paul Components brakes.

The Camera Mount is designed to securely attach a GoPro camera to the top of a threadless stem. Designed to replace the top cap of a 1 1/8” threadless stem, it gives you a view right across the top of your handlebars and down the trail....

These Canti-Levers feature a very comfortable grip, and an excellent feel. They also have a reach adjustment screw, an un-strippable clamp screw and our nice Hollow Lite pivot pin. The Canti Lever is a short pull brake lever for use with...

The Chain Keeper is a guide to keep your chain right where it belongs. Mounted in place of a front derailleur, the Chain Keeper works with single chain ring drivetrains using a narrow chain. The chain block surrounds the chain as it...

100% Pure Crank from Paul Component Engineering. Strong, elegant & classy. Paul Components Road Cranks take advantage of the narrower chainstays found on road frames, and the 44mm chainline of Paul Components High Flange hubs.These...

The Cross Lever fits onto the thicker stem clamp area of handlebars, and a hinged clamp allows for installation without needing to strip your bar tape. The Cross Lever is an in-line brake lever designed for use on the flat upper section...

This is a disc brake equipped version of Paul's venerable FHUB front hub. The Disk FHUB features a six bolt ISO mount for disc brake rotors with front disc spacing. The flanges have been increased in diameter make room for the disc mount...

Running brakes on your fixie but want to keep the bars looking clean and trackish? This is the answer.There's something to be said for the clean looks of bare track handlebars, but riding brakeless can be hazardous on the road. The...